Thermolog can be configured in two ways. One by using the buttons and the menu that will appear on the display, or by using Modbus and commands from the dedicated Thermometer PC application or any other software with Modbus function. The offered device has default parameters and you should set them according to your requirements.
It is possible to configure:
- the display method
- brightness from 1 to 15 or automatic
- Modbus parameters
- date and time
- sensor calibration
Configuring with buttons
To set the time on the Thermolog ATL-V3-TH:
- Long press the OK button to enter the time setting mode.
- Use the Left (L) and Right (R) buttons to adjust the time.
- Single press the OK button to switch between setting up minutes, hours, days, and so on.
- This allows you to easily navigate through the different time units and adjust them accordingly.
To switch the display mode:
- Press either the Right (R) or Left (L) button.
To set Brightness of display and Modbus Parameter:
- Press the OK button along with the Right (R) button to set Modbus address, baudrate, parity, stop bit and also set brightness to manual or auto.
- Use the Left (L) and Right (R) buttons to adjust the parameter.
- Single press the OK button to switch between parameters.
To set temperature and humidity alert:
- To set the minimum or maximum temperature of the sensor for low or high temperatures, use the OK button along with the Left (L) button.
- Use the Left (L) and Right (R) buttons to adjust the temperature.
- Single press the OK button to switch between low and high temperature.